Tile Adhesive White, Polymer modified, cement-based wall and floor tile adhesive suitable for fixing tiles and natural stones in interior/exterior use, including swimming pools.
Surfaces to be tiled must be dry and fully cured, clean and free from all contamination. Existing unglazed ceramic tiles, vitrified & fully vitrified tiles, terrazzo and natural stone should be firmly bonded and any hollow or defective areas should be cut out and made good.
Grouting should not be carried out for at least 24 hours. Use ADHERE BOND CTG (Cementitious grout) and ADHERE BOND ETG (Epoxy grout) for grouting..
This will depend on the nature and flatness of the surface and the method of application, but at 3 mm thickness, it is approximately 3.5 Kg/m² when using a solid-bed trowel. For good coverage, it is vitally important that all surfaces should be clean, smooth, plumb, level and free from defects and undulations.
Add clean water to ADHERE BOND 007 and mix thoroughly until a lump-free mortar is obtained. A 25 kg bag will require approximately 7 liters of water. The adhesive is immediately ready-for-use and has a pot life of 3 hours. No further water should be added.
Whilst any information and / or specification contained herein is to the best of our knowledge true and accurate, no warranty is given or implied in connection with any recommendation or suggestions made by us, our representatives, agents or distributors as the conditions of use of any labour involved are beyond our control.