1800-425-2383 | 94440 82770 | 94440 82750

Acrylic Polymer Based

Our Brochures

Adhere-Cure-Polymer.Pdf
adhere-cure

ADHERE CURE Polymer Based

ADHERE CURE is a non-degrading, membrane-forming liquid based on specially formulated acrylic polymer for curing newly placed or freshly de-shuttered concrete; assists in the retention of water during hydration. The resultant film retains sufficient moisture in the concrete to ensure full hydration of the cement; essential for optimum strength development. The cured concrete is typically harder and exhibits a dust free surface with a reduced incidence of drying shrinkage cracks. Additionally, the membrane acts as a primer system for many subsequent surface-finishes that do not rely on penetration for substrate bonds. When applied to floors, the ADHERE CURE seals and dustproof the surface, eliminating the primary source of abrasion while enhancing durability.

  • - Improves moisture retention in concrete
  • - Prevents rapid water evaporation
  • - Sealer & dust proofer
  • - Good abrasion resistance - long protection
  • - Reduces drying shrinkage
  • - Reduces the incidence of hairline cracks
  • - High curing efficiency
  • - Non - degrading - no removal required
  • - Act as primer for protective coatings
  • - ADHERE CURE is a more effective and economical alternative to separate curing and priming/sealing regimes and suitable for use on all concrete surfaces.
  • - Surfaces subject to finishing treatments.
  • - Economical enhancement of concrete flatwork.
  • - In high-rise construction to eliminate the requirement for water.
  • The recommended rate of application is 4-6 square meters per liter. This corresponds to that at which ADHERE CURE has been tested, and at which it attains the claimed degree of curing efficiency. In favorable conditions such as shaded interior surfaces, adequate curing can be achieved with extended coverage rates.
  • When using ADHERE CURE for floor areas where maximum chemical and wear resistance is required, it is recommended that a further coat be applied after 24 hours.
  • In place of the above recommendations, the rates of cover stipulated in a specification should at all times be observed.

ADHERE CURE Store under cover, out of direct sunlight and protect from extremes of temperature. Shelf life is 6 months when stored as above. Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging.

Note:

Whilst any information and / or specification contained herein is to the best of our knowledge true and accurate, no warranty is given or implied in connection with any recommendation or suggestions made by us, our representatives, agents or distributors as the conditions of use of any labour involved are beyond our control.