Ready –Mix Plaster is manufactured in advanced dry mix plant with latest technology process. Plaster is ready to use by just mixing water at site. This process eliminates job-site mixing practices. Hence it gives consistent quality with required sand mesh sizes in exact proportion which is most important for compactness of plaster. Further to have desired work ability, less rebounding losses, required slump properties and overall durability.
The substrate needs to be cleaned and made tree from grease and loose particles. The porous and absorbent substrates need to be pre – wetted prior to application ADHERE PALST Ready – Mix Plaster to prevent premature loss of water from the plaster. This will ensure that thin layer can be applied without cracking problems and proper cement hydration and adherence of the substrate is attained.
Allow plaster to the substrate , using some pressure while finishing with a steel trowel or wooden float to ensure optimum bonding of the plaster to the substrate. ADHERE PLAST Ready – Mix Plaster can be used for interior as well as exterior wall..
Use 7-8 liters of water for 40 kg ADHERE PLAST Ready – Mix Plaster. Pour the same, while mixing for 4-5 minutes with hand or still better with a mechanical mixer to achieve a good consistency. Do not over mix.
· Allow mixture to stand for 2-3 minutes for additives to dissolve . Re- mix again for about 2 minutes, plaster is ready for use.
Whilst any information and / or specification contained herein is to the best of our knowledge true and accurate, no warranty is given or implied in connection with any recommendation or suggestions made by us, our representatives, agents or distributors as the conditions of use of any labour involved are beyond our control.