Elastomeric Membrane Coating System – Polymer modified, Cementitious, Waterproofing Coating System which forms a highly elastic water impermeable membrane. It consists of a liquid and powder when mixed together forms an easily brushable coating..
Over the prepared surface apply the well-mixed AQUALASTICslurry with brush or broom. If used on smooth, screed floors, application can be done also by notched trowel and then level with a spiked roller. Do not apply more than 1 mm per layer. The next layer can be applied as soon as the preceding one is dry enough to be wiped i.e. as soon as it can be walked on, but it is recommended to wait overnight. AQUALASTIC can be sprayed also. The total thickness of 2 coats of AQUALASTIC would be 1.5 mm to 2 mm..
Homogeneous hardening and high waterproof are assured. AQUALASTIC does not dry too quickly; therefore it should be protected after application against heavy wind and intense sunshine.,PACKING:-6,24Kgs.
Curing and hardening depends on the temperature. At 30˚C, AQUALASTIC floor is walkable after about 8 hours and resistant to mechanical stress after 3 days. Full hardening is reached after about 7 days. After this time, the coating resists permanent water pressure.
Whilst any information and / or specification contained herein is to the best of our knowledge true and accurate, no warranty is given or implied in connection with any recommendation or suggestions made by us, our representatives, agents or distributors as the conditions of use of any labour involved are beyond our control.