ADHERE BONDS-CTG is a highly quality fine, waterresistant cement based powder grouting compound designed for grouting glazed wall tiles, mosaic, vitrified and fully vitrified tiles, ceramic floor tiles, industrial floor tiles etc. where chemical resistant is important use our ADHERE BONDS-ETG (Epoxy Tile Joint Grout).
Before commencing grouting the adhesive bed must be set. Fix in a solid bed of adhesive i.e. ensuring that, as far as possible no voids are left behind / beneath the tiles. Protect open joints from contamination and ensure that they are clean, dry and free loose debris prior to grouting. Do not use in damp condition.
Mix the ADHERE BONDS-CTG with clean water until a lump-free smooth paste of uniform colour is obtained. If an electric drill mixer is used blend on a slow speed (less than 300rpm). Avoid entraining air by mixing at too high speed or by over-mixing. Do not reconstitute the mixed grout by adding more water, this will reduce the final strength.
|Joint width||2 - 6 mm|
|Pot Life@ 27°C||30 Minutes|
|Setting time at 27°C||24 Hours|
|Water Grout Ratio||1 : 3|
|((Tile length + Tile breadth) x Tile thickness x Specific gravity)
((Tile length + Joint width) x (Tile breadth + Joint width))
12 months when stored in ideal storage conditions.
1 Kg pack.
Whilst any information and / or specification contained herein is to the best of our knowledge true and accurate, no warranty is given or implied in connection with any recommendation or suggestions made by us, our representatives, agents or distributors as the conditions of use of any labour involved are beyond our control.